Troubleshooting; What To Do If - Zanussi ZDC47200W User Manual

1. Open the small door at
the lower part of the cabi-
net

What to do if ...

Troubleshooting by yourself
1)
Problem
Dryer not connected to mains supply.
Dryer does not
work. Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
To little free space around the appliance
2. Turn the yellow stop
upwards
3. Pull out the reservoir
4. Open the small cover
and let water flow down
5. Close the small cover
and re-insert correctly the
reservoir
6. Push it until it clicks
and turn the yellow stop
downwards firmly lock it.
7. Close the small door
and press the START/
PAUSE button again to al-
low the programme to
continue.
Possible cause
Cleaning the drum
Caution! Do not use abrasives or steel wool to clean
the drum.
Lime in the water or cleaning agents may form a
barely visible lining on the inside of the drum. The
degree to which the laundry has been dried is then no lon-
ger detected reliably. The laundry is damper than expected
when removed from the appliance.
Use a standard domestic cleaner (e.g. vinegar-based
cleaner) to wipe down the inside of the drum and drum
ribs.
Clean control panel and housing
Caution! Do not use furniture cleaners or aggressive
cleaning agents to clean the machine.
Use a damp cloth to wipe down the control panel and
housing.
Plug in at mains socket. Check fuse in fuse box
(domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Ensure min. 5cm free space around the appli-
ance
Remedy
2)
3)
3)
13