Zanussi ZDC47200W User Manual page 6

Warning! The plug must be accessible after
installing the machine.
Permanent connection
In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap of
3 mm between the switch contacts and of a type suitable
for the required load in compliance with the current elec-
trical regulations.
The switch must not break the yellow and green earth ca-
ble at any point.
Door reversal
To make it easier to load or unload the laundry, the door
can be reversed.
Warning! The door must only be reversed by an
authorised service engineer.
Please contact your local Service Force Centre. The engi-
neer will carry out the door reversal at your cost.
Special accessories
• stack kit
Available from your Service Force Centre or your
specialist dealer
6
These intermediate installation kits can be used to ar-
range the dryer and an washing machine (60 cm wide,
front loaded) as a space-saving washer/dryer stack.
The washing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the kit.
• drain kit
Available from your Service Force Centre or your
specialist dealer
Installation kit for direct draining of condensate into a
basin, siphon, gully, etc. The condensate tank then no
longer has to be drained, it must however remain in its
intended position in the machine.
Read carefully the instructions supplied with the kit.
• pedestal with the drawer
Available from your Service Force Centre or your
specialist dealer
To situate the dryer in optimal high and have some ad-
ditional space to store (e.g. laundry).
Read carefully the instructions supplied with the kit.