Zanussi ZDC47200W User Manual page 12

1. Open loading door
3. Use a damp hand to
clean the micro- fine filter,
which is built into the low-
er part of the loading aper-
ture.
Cleaning heat exchanger
Clean the condenser when light Condenser comes on.
The condenser is situated at the lower part of the cabinet
behind a small door.
12
2. After a period of time, a
patina due to detergent
residue on laundry forms
on the filters. Then clean
the filters with warm water
using a brush. Remove the
filter from the door pulling
it out.
4. Remove fluff from lint
filter, preferably using a
damp hand for this pur-
pose.
Replace the filter.
1. To open the door, push
the catch as per picture.
During the drying cycle or
at the end, it is normal for
water to be present on the
surface of the condenser
insertion.
3. Pull out the condenser
unit holding it at the han-
dle .
Important! Do not use pointed objects or utensils to clean
the spaces between the plates, as this could damage the
condenser and make it permeable. Re-fit the condenser,
turn the red stops upwards and close the door.
Important! Do not use this appliance if the condenser has
not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses inside the
machine and is collected in a reservoir. The reservoir
must be emptied after each drying cycle to ensure efficient
operation when the machine is next used. The pilot light
Tank reminds you this operation.
2. Turn the two red stops
downwards.
4. Clean it with a brush
and rinse it under the
shower if necessary. Also
clean the outside, remov-
ing all fluff. Clean the rub-
ber seal round the con-
denser cabinet and in the
inner part of the small
door with a damp cloth.