Table of Contents
Advertisement
REPLACING THE BATTERIES
WARNING: To avoid electric shock, disconnect the test leads
from any source of voltage before removing the battery door.
1.
When the batteries become exhausted or drop below the
operating voltage, "BAT" will appear in the right-hand side of
the LCD display. The batteries should be replaced.
2.
Follow instructions for installing batteries. See the Battery
Installation section of this manual.
3.
Dispose of the old batteries properly.
WARNING: To avoid electric shock, do not operate your meter
until the battery door is in place and fastened securely.
REPLACING THE FUSES
WARNING: To avoid electric shock, disconnect the test leads
from any source of voltage before removing the fuse door.
1.
Disconnect the test leads from the meter and any item under
test.
2.
Open the fuse door by loosening the screw on the door
using a Phillips head screwdriver.
3.
Remove the old fuse from its holder by gently pulling it out.
18
Advertisement
Table of Contents
