Resistance Measurements - Pyle PDMT08 Manual

RESISTANCE MEASUREMENTS

WARNING: To avoid electric shock, disconnect power to the unit
under test and discharge all capacitors before taking any
resistance measurements. Remove the batteries and unplug the
line cords.
Set the function switch to the highest  position.
1.
2. Insert the black test lead banana
plug into the negative (COM) jack
Insert the red test lead banana
plug into the positive  jack.
3. Touch the test probe tips across
the circuit or part under test. It is
best to disconnect one side of the
part under test so the rest of the
circuit will not interfere with the
resistance reading.
4. Read the resistance in the display and then set the function
switch to the lowest  position that is greater than the actual
or any anticipated resistance. The display will indicate the
proper decimal point and value.
15