Advertisement
Clamp size
Diode Test
typical.
Continuity Check
Low Battery Indication
Overrange Indication
Measurements Rate
Input Impedance
Display
AC Current
AC Voltage bandwidth
Operating Temperature
Storage Temperature
Relative Humidity
Altitude
Over voltage
Battery
1000 to1300oF
I
±
(3 .0% reading + 10°F)
Opening 0.9" (23mm) approx
Test current of 0.3mA typical; Open circuit voltage 1.5V DC
Threshold < 1000; Test current < 1 mA
"
...
" is displayed
"O~'
is displayed
2 per second
,
nominal
7.BMQ (VDC and VAC)
4000 counts LCD
50/60Hz (AAC)
50/200Hz (VAC)
14 to 122°F (-10 to 50°C)
-14 to 140°F (-30 to 60°C)
90%(0°C to
30°C);
75%(30°C to
40°C);
45%(40°C to 50°C)
Operating:
3000m; Storage 10,000m
Category III 600V
Two 1.5V
"AAA"
Batteries
approx.
30 minutes
200x50x35mm/200g
Auto OFF
DimensionslWeight
Safety
For indoor use and in accordance with Overvoltage Category
II, Pollution Degree
2.
Category II includes local level
,
appliance, portable equipment, etc.
,
with transient
overvoltages less than Overvoltage Cat. III
Operation
NOTICES:
Read and understand all warning and precaution statements listed in the
safety section of this operation manual prior to using this meter. Set the function
select switch to the OFF position when the meter is not in use.
AC Current Measurements
WARNING: Ensure that the test leads are
disconnected from the meter before making current
clamp measurements.
1.
Set the Function switch to the 400 or40A or
4A range
.
If the range of the measured is not known,
select the higher range first then move to the lower
range if
necessary.
NO
2. Press the trigger to open
jaw.
Fully enclose one conductor
to be
measured.
The clamp meter LCD will display the reading.
DC/AC Voltage Measurements
CIIJ
~t@
1.
Insert the black test lead into the negative COM terminal and the
red test lead into the positive V terminal.
2.
Set the function switch to the V position.
3.
Select AC or DC with the MODE button
.
YES
Advertisement
