Weslo Momentum 750 Elliptical User Manual page 6

2. While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (28) to the Frame with two
M10 x 75mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
3. The Console (23) requires three "AA" batteries (not
included); alkaline batteries are recommended. Insert
three batteries into the battery compartment. Make
sure that the batteries are oriented as shown by
the diagram inside the battery compartment.
4. While another person holds the Console (23) near the
Upright (2), connect the console wire to the Upper
Wire (44). Insert the console wire and the Upper Wire
into the Upright.
Attach the Console (23) to the Upright (2) with four M4
x 16mm Screws (42). Be careful to avoid pinching
the console wire or the Upper Wire (44).
Turn the Resistance Knob (63) counterclockwise to
the lowest setting before continuing to the next
step.
5. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire (44) to the Reed
Switch Wire (53).
Next, connect the Resistance Cable (63) to the Lower
Cable (55) in the following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (55), and insert the tip of the
Resistance Cable (63) into the wire clip inside of the
metal bracket.
• See drawing B. Firmly pull the Resistance Cable
(63) and slide it into the metal bracket on the Lower
Cable (55) as shown.
• See drawing C. Using pliers, squeeze together the
prongs on the upper end of the metal bracket.
Push the excess cable and wire down into the Frame
(1). Slide the Upright (2) onto the Frame. Be careful
not to pinch the wires or cables. Secure the Upright
to the Frame with two M10 x 66mm Button Bolts (48),
two M10 Split Washers (59), and two M10 Nylon
Locknuts (33). Do not tighten the Button Bolts yet.
2
33
1
3
23
4
Console Wire
44
42
5
33
63
55
A
Metal
Bracket
63
55
6
28
33
34
Batteries
23
2
63
2
Make sure that
the wires and
59
cables do not
48
get pinched
and damaged
during this
44
step.
53
1
B C
63
63
55
55