Kuppersbusch IGS 644.1 Installation Manual

Brief and handy:
en
everything your dishwasher
needs...
Before using for the first
time, read the installation
and operating instructions!

Fill with special salt

Fill with rinse aid

Fill with detergent

Select programme

Switch on appliance
Press On/Off switch, running time of the
chosen programme appears
Switch off the appliance
When the display shows 0:00 (end of programme),
press On/Off switch

Adjusting the water softening system *

Request the water hardness
value in your area from your
water supply company and
enter it here ...
* only before first use
of the appliance or if
the water hardness
changes
Dissolves limescale (not required for set value 0!)
Unscrew
the lid.
Everything is sparkling clean ...
Press mark 1,
lift up lid 2.
Very dirty dishes, a lot of detergent ...
If required, open
the lid (press the
pin).
Quick, economical or intensive
Programme Overview
This overview shows the maximum number of programmes
available. You'll find the corresponding programmes of your
device on your control panel.
The programme data are laboratory read-
outs according to
European Standard EN 50242.
In practice, deviations are possible.

Additional programmes **

Soak
...crockery in the lower
basket, programme
starts automatically,
Everything O.K...
remember to add an
extra 5g of cleaning
agent when the door
unlocks.
Read off the correct setting for your water hardness
Only before using
the dishwasher
for the first time
pour approx. 1 l /
2 pt water into the
salt opening.
Warning,
combination
products are not
suitable for all
programmes,
follow manufac-
turer's instructions.
Duration: hs/mins
Energy Consumption: kWh
Water Consumption: litres
With Aquasensor
Increased flexibility ...
Time reduction/ Upper basket cleaning
...Only the crockery in the
time saving
upper basket is cleaned
...shortens the
cleaning time, reduces
the drying.
** on some models
Quickly sorted
How to adjust the water softening system
– Hold down programme button B and press main switch
until the digital display illuminates, then release the buttons.
The LED for button B flashes and the digital display
displays the factory setting H:04.
– Each time button B is pressed, the setting increases by 1;
after H:07, the setting goes back to H:00 .
– Switch off the main switch. The chosen setting has now
been stored.
Pour in max.
1.5 kg / 3 lb 5 oz
salt (never deter-
gent!)
Refill whenever level indicator is light!
Pour in
rinse aid.
Pour in
detergent.
Intensive Auto Eco Gentle
70 55 /65 50 40
1:52 1:35-2:25 2:20 1:12
1,60 1,15-1,50 1,05 0,80
21 11–19 14 15
18 – – 12
Lower basket cleaning
...Only the crockery in the
lower basket is cleaned
Screw on the
lid. Switch on
dishwasher
immediately.
Close the
lid. CLICK!
Push the lid
shut, press.
PLOP!
Quick
Prerinse
45
0:30 0:19
0,70 0,10
10 4
– –
Time selection
...switches on as soon as
you press the time
h.
selection button:
Alters the programme
start in hourly steps