Table of Contents
Advertisement
Using the DriveRight 600
Using the DriveRight 600
This section briefly describes the DriveRight 600
four buttons (PLUS, MINUS, MODE, SET/CLEAR) and the sequence of
Data Screens and Settings Screens. Descriptions of the information and
options available from each screen are explained separately in "Data
Screens" starting on page 8 and "Settings Screens" starting on page 15.
Note: Never attempt to change the DriveRight 600
requires extreme attentiveness. Changing the DriveRight 600
may result in dangerous distraction. Only use the device when you are not operating
your vehicle. Always warn drivers about the DriveRight 600
sounds, a driver who has not been warned may be startled or get distracted trying to
trace the source of the noise. In either case, it may create a safety concern, so warn
drivers in advance.
Using the Four Buttons
The DriveRight 600
MODE. The general use of each button is explained briefly below:
• PLUS (+) and MINUS (-) — Use PLUS and MINUS to toggle options
On or Off, or to scroll through the ten digits possible (0-9) when
entering a number (usually for entering or setting the Driver ID code, or
changing the date and time).
Also, use PLUS and MINUS to page forward or backward
(respectively) through the stored trips or logs.
• SET/CLEAR — When entering codes, the flashing digit/segment
indicates what will change if PLUS or MINUS is pressed. Pressing and
releasing SET/CLEAR causes the next digit/segment to flash.
From the Driver ID Code Screen, press and hold SET/CLEAR (for at
least 2 seconds) to "log out." The Driver ID code is reset to 0000. In the
Current Readings Screen, press and hold SET/CLEAR for 2 seconds to
toggle between the two available units of measure (mph and km).
In the Date Entry and Time Entry Screens, press SET/CLEAR until the
entry flashes and use PLUS and MINUS to scroll through the options.
• MODE — Press and release MODE to move to the next data or
information screen. Press and hold MODE to switch between the Data
Screens and the Settings Screens. When the DriveRight 600
mode, press MODE to "wake" it up.
DriveRight 600
The DriveRight 600
the stored data (Data Screens) and screens for changing and updating the
DriveRight 600
2
E
has four buttons: PLUS, MINUS, SET/CLEAR, and
E
Screens
E
contains several screens for viewing and navigating
E
settings (Setting Screens).
E
E
display, the use of the
E
display while driving. Safe driving
E
display while driving
E
's alarms. If an alarm
E
is in sleep
E
Advertisement
Table of Contents
