Trip Start/End Log Screen - DAVIS 8126GD User Manual

Driveright 600e

Hide thumbs

Table Of Contents

Table of Contents

Note: Driver ID code 0000 (four zeros) is used to view information for the vehicle

(all drivers) and should not be assigned to any driver.

In addition to marking data as belonging to a particular driver, the

Driver ID code may be used on the device to filter the information

being viewed. To view information for one specific driver, enter that

Driver's ID code in this screen. The DriveRight 600

any data not assigned to that code. To view all information, regardless

of Driver ID Code, enter 0000.

The following options are available in the Driver ID Code Entry

Screen:

• Enter a Driver ID Code — When the Driver ID Code Entry Screen

is first displayed, the first digit to the left flashes, indicating that it is

the active digit. Press and release PLUS or MINUS to cycle forward

or backward through the available entries for the active digit (0 to 9).

To change the digit which is active, press and release SET/CLEAR.

The digits are cycled through each time SET/CLEAR is pressed.

Only the Driver ID codes that have been programmed into the

DriveRight 600

wrong ID code is entered. A code of "0000" is still accepted.

• Log Out — Press and hold SET/CLEAR for 2 seconds, until the

code resets to 0000. As soon as a driver logs out, the current trip is

ended and data for that trip is stored in the DriveRight 600

memory. Do not log out when the vehicle is in motion.

Two Digital Inputs

Two digital inputs are available on the DriveRight 600

operation of lights or other electrically powered accessories on the

vehicle. A typical application would be to monitor the headlights and

the brakes. The screen displays "1" if the input is high, and "0" if the

input is low. The status of the inputs is stored in the trip log.

Activity Indicator

Primarily useful for troubleshooting the installation, the small "dot"

between the two activity indicators displays whenever the reed switch

used with the General Duty (# 8126GD) and Heavy Duty (# 8126HD)

models is closed, or whenever the VSS input used with the VSS (#

8126VSS) model is high. The reed switch closes once each time the

vehicle's drive shaft rotates.