Saeco Nina cappuccino Operating Instructions Manual page 19

• (Fig.1 - 2) - when the descaling solution is finished,
remove the water tank, rinse it and fill it with fresh drinking
water.
• (Fig.1) - Reinsert the tank into the machine.
• (Fig.4) - Place a container under the steam spout.
• (Fig.5 - 6) - Open the knob (4) and set the selection knob
(17) to the " " position to empty 2/3 of the water. To
stop brewing switch the selection knob (17) to the "
position and close the knob (4).
• Let the machine warm up and empty the water tank as
described above.
if you are using a product other than the
recommended one it is however important to
follow the manufacturer's instructions shown on the
descaling solution box.
11 CAPPuCCinAtoRe (oPtionAl)
Not all machine models are provided with
cappuccinatore. The cappuccinatore allows you to easily
and quickly prepare delicious cappuccinos.
Follow these simple instructions to install it.
1 (Fig.29) - Loosen the ring nut on the upper part of the
cappuccinatore.
2 Insert the cappuccinatore completely into the steam
spout.
3 (Fig.30) - Tighten the ring nut.
To use the cappuccinatore, prepare the machine as
described in the related sections.
Before using the accessories, we recommend washing
them with water (Fig.31-32), immerse the suction pipe
in a fresh water container and eject a small quantity of
steam (please refer to the related instructions). In this
way, the accessories will be perfectly clean before use.
to clean the cappuccinatore, suck up clean water
to clean the suction pipe.
While the machine is getting ready, prepare a special
container with milk or use the milk container. Place it
beside the machine.
• (Fig.33) - Immerse the suction pipe in the prepared
milk.
• (Fig.34) - Eject steam as described in section 8. Turn the
pin to modify the milk froth.
Lift the pin gently to obtain more froth.
• After preparing the cappuccino, immerse the suction
pipe into a container with fresh clean water and eject
steam. The cappuccinatore is clean when clean water is
dispensed. Clean the suction pipe externally with a damp
cloth.
the cappuccinatore must be removed and
completely washed once a week.
Wash the cappuccinatore as follows:
• (Fig.35) - Remove the extremity of the cappuccinatore
from its seat.
• Separate the cappuccinatore's components.
Warning. Do not use steam when the extremity of
the cappuccinatore is not inserted into its seat.
"
• (Fig.36) - Wash the cappuccinatore extremity with
lukewarm water. Make sure no dirt is left inside.
After washing the components of the cappuccinatore,
place it back on the coupling located on the machine.
11 DisPosAl
• Put unused appliances out of service.
• Disconnect the plug from the socket and cut the electrical
cord.
• At the end of its life, take the appliance to a suitable waste
collection site.
This product complies with EU Directive 2002/96/EC.
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical
and electronic equipment.
By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise
be caused by inappropriate waste handling of this
product. For more detailed information about recycling
of this product, please contact your local city office, your
household waste disposal service or the shop where you
purchased the product.
• 1 •