Installing The Software For Windows 95 - Epson Stylus Photo User Manual

If you are using the floppy disk version of the software, before
you begin installation, make a backup copy of the EPSON
printer software disk. If you wish to make a floppy disk version
of the printer software on your CD-ROM, you can use the
driver disk creation utility included on the CD. See page 2-15
for Windows 95, or page 2-18 for Windows 3.1.

Installing the software for Windows 95

Follow these steps to install the printer software using
Windows 95 plug-and-play capabilities. If you are using
Windows 3.1, see page 2-18 for instructions.
Note:
To install the printer software using Windows 95 plug-and-play
capabilities, your computer's parallel port must be an IEEE-1284
compatible, bidirectional parallel port. See your computer
documentation for more information.
1. Make sure the printer is connected to the computer's parallel
port.
2. Turn off your printer and computer, if necessary.
3. Turn on the printer first; then turn on the computer. Your
computer begins loading Windows 95.
4. If you defined a password, enter it at the prompt. You see the
New Hardware Found screen.
Note:
If you do not see the New Hardware Found screen, please follow
the procedure under ''Installing the software while running
Windows 95'' on page 2-14 instead.
2-12
Getting Started