Table of Contents
Advertisement
IPGSM-DP Commercial Fire Communicator – Installation and Setup Guide
iGSM Communications Module Information
ON – NOT registered with AlarmNet.
OFF – Registered with AlarmNet.
FAST BLINK – Download session with Compass
SLOW BLINK – In unison with yellow LED,
ON – Message transmission pending.
QUICK PERIODIC BLINK – Normal.
FAST BLINK – Message waiting for network ACK.
SLOW BLINK – Idle power abnormal.
SLOW BLINK – In unison with green LED,
ON – No contact with network.
OFF – Normal.
SLOW BLINK – Loss of communication with the
Dialer Capture Module
FAST BLINK – No network contact AND loss of communi-
cation with the
Note: If all LEDs FAST BLINK in unison with
the RSSI LEDs this indicates a Hardware Error.
BLINKING – Network collision detected.
OFF – Normal.
ON – 100 MB/S link to Internet.
OFF – 10 MB/S link to Internet.
ON – Ethernet Link detected.
OFF – No link detected.
FAST BLINK – Transmitting/Receiving Data.
MODULE'S RECEIVED SIGNAL STRENGTH (RSSI)
When the Mode Switch is NOT depressed, LED 1 will illuminate red.
The remaining LEDs indicate RSSI (Received Signal Strength).
MODULE'S OPERATION MODE
When the Mode Switch IS depressed, LED 1 will be OFF.
LEDs 2 and 3 indicate the module's communication mode with the Dialer Capture Module.
Mode
ECP
Zone (NOT USED)
4204 (NOT USED)
2 - 4204 (NOT USED)
MODULE'S STATUS
When the Mode Switch IS depressed, LED 1 will be OFF.
LEDs 4, 5, and 6 indicate the module's Status.
LED 4 (green)
ON - Connected to
Internet.
OFF - Not connected
to Internet.
in progress.
registration in progress.
registratration in progress.
(ECP fault).
Dialer Capture
Module.
LED 2 (yellow)
OFF
ON
OFF
ON
LED 5 (green)
ON - GPRS service
available.
OFF - No GPRS service
available
FAST BLINK - GPRS in
use.
GRN
7720P
Programmer
Port
YEL
TB 1
1
2
3
4
5
6
RED
7
8
9
10
11
Network Collision
YELLOW
Link Speed
GREEN
Ethernet Link/Activity
GREEN
LED 3 (yellow)
OFF
OFF
ON
ON
LED 6 (green)
ON - Module registered, no second
site available.
OFF - Module not registered with
network carrier.
SLOW BLINK - Module registered, second
site available, and low signal strength.
NORMAL BLINK - Module registered, second
site available, acceptable signal strength.
FAST BLINK - Module registered, second
site available, excellent signal strength.
– 10 –
PRIMARY POWER: 9 - 16.5 VAC
CURRENT: 900mA PEAK, 70mA STANDBY
BATTERY: 8V. 3.1 AHr FOR 24 Hr BACKUP
FCC:XXXXXXXXXX
IC: YYYYYYYYYY
RSSI / Mode
and
status LEDs
Tamper
Switch
Mode
Switch
Advertisement
Table of Contents
