NordicTrack Gx 2.7 Bike Manual page 12

10. Untie and discard the wire tie on the Main Wire
Harness (25). Insert the Main Wire Harness
upward through the Handlebar (4) as shown.
While a second person holds the Console (7)
near the Handlebar (4), plug the Main Wire
Harness (25) and the Pulse Wire Harness (23)
into the receptacles on the Console.
Then, insert the excess wire into the Handlebar (4).
11. Tip: Avoid pinching the wires. Attach the
Console (7) to the Handlebar (4) with two M4
x 16mm Screws (2) in the lower holes in the
Handlebar.
12. Slide the Console Cover (3) upward to the
Handlebar (4). Attach the Console Cover to the
Handlebar and to the Console (7) with two M4 x
16mm Screws (2).
Next, insert the Handlebar Knob (1) into the
Console Cover (3) and into the Handlebar (4),
rotate the Handlebar to the desired angle, and
then tighten the Handlebar Knob.
10
7
11
7
Avoid pinching
the wires
12
4
12
25
4
23
4
2
7
2
3
1