Channels - Philips PFL3xx8H/T User Manual


[Advanced]: Access advanced settings
to enhance your audio experience.
- [Auto volume levelling]:Enable the
reduction of sudden volume changes,
for example, when switching channels.
- [TV speakers]: Select the preferred
speakers to stream audio from the TV.
See Connect your TV > Set up
EasyLink devices > Select speaker
output (Page 35).
- [Clear Sound]*: Enhance sound
quality.
- [Audio Out format]: Select the type
of audio output through the digital
audio output connector. Choose
between [Multichannel] and [Stereo].
*Available on certain models only.
- [HDMI 1 - ARC]: Enable audio
output from the ARC-compliant device
connected to the HDMI 1 connector.
- [Audio out delay]: Automatically sync
the image on the TV to the audio from
a connected home theatre. You do not
need to use this setting when
connecting the TV to a Philips home
theatre.
- [Audio out offset]: Adjust the setting
for audio output delay. Available if
[Audio out delay] is switched on.
Audio format
If an analogue TV channel broadcaster
streams stereo audio in multiple formats, you
can select an audio format.
1. Press .
2. Select [Setup] > [Channel settings] >
[Mono/Stereo].
3. Select a setting, then press OK.
Reset picture and sound
You can restore the default picture and
sound settings, while the channel installation
settings remain the same.
1. While you watch TV, press .
2. Select [Setup] > [TV settings] > [General
settings] > [Factory settings], then press
OK.
3. Select [Reset], then press OK.
All TV settings (except for channel settings)
are reset to the default factory settings.

Channels

Automatic installation
When the TV was switched on for the first
time, a full installation of channels was
performed.
To change your language, country and
reinstall all available TV channels, you can run
this full installation again.
Start installation
Note: If you are prompted to enter a code,
enter '8888'.
1. Press .
2. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
3. Select your country, then press OK.
4. Select your network, then press OK:

[Antenna (DVB-T)]: Access free-to-air
antenna transmissions.

[Cable (DVB-C)]: Access cable
transmissions.
5. Follow the onscreen instructions to select
other options, if any.
The start menu for channel search is
displayed.
6. Select [Start], then press OK.
7. Once the channel search is complete,
select [Finish], then press OK.
Tip: Press LIST to see the channel list.
Note: When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can rename
these channels.
EN 21