Usb (Powered By External Power Supply) - Honeywell MS4980 Installation And User Manual

USB (Powered by External Power Supply)

1. Turn off the host device.
2. Plug the 15-pin socket end of the
cable into the 15-pin D-Type
connector on the MS4980
(see page 4).
3. Plug the USB end of the cable into
the host's USB port.
4. Plug the power supply into the power
jack on the PowerLink cable.
5. Check the AC input requirements of
the power supply to verify the
voltage matches the AC outlet.
The outlet must be located near the
equipment and be easily accessible.
6. Connect AC power to the
transformer.
7. The MS4980 will start to initialize.
The white and blue LED will
alternately fade on and off for
approximately three seconds. When
the scanner has finished initializing,
the unit will flash the white LED three
times while simultaneously beeping
three times. The low intensity blue
LED will remain turned on.
8. Turn on the host device. The scanner will automatically reboot after host
device is turned on.
Installation Note
Plugging the scanner into a port on the host system does not guarantee that
scanned information will be communicated properly to the host system. Please
refer to the MetroSelect Single-Line Configuration Guide or MetroSet2's help files
for instructions on changing the scanner's factory default configuration. The
scanner and host system must use the same communication protocols.
See caution on page 5.
10
Figure 9.