Anti-Tip Bracket; Leveling - GE 164D3333P150 Owner's Manual

Installation of the range.
Read these instructions completely and carefully.
8
Anti-Tip Bracket Installation
An Anti-Tip bracket is supplied with instructions for installation in a variety
of locations. The instructions include a template, a parts list and a list of tools
necessary to complete the installation. Read the Important Safety Information
and the instructions that fit your situation before beginning installation.
WARNING
Range must be secured by Anti-Tip bracket supplied.
See instructions to install (supplied with bracket).
Unless properly installed, the range could be tipped by stepping or sitting on
the door. Injury might result from spilled hot liquids or from the range itself.
9
Leveling the Range
The range must be level. Leveling feet are located at each corner of the base of
the range. Remove the storage drawer or kick panel (depending on your model)
and using channel locks, rotate the leveling feet in and out as required to level
the range. (For instructions on how to remove and replace the storage drawer or
the kick panel, see the Care and cleaning of the range section.)
On some models, there are plastic covers which may be removed for easy
adjustment (just squeeze and pull).
One of the rear leveling feet will engage the Anti-Tip bracket (allow for some side
to side adjustment). Allow a minimum clearance of 1/8² between the range and
the leveling foot that is to be installed into the Anti-Tip bracket.
Check the range for proper installation into the Anti-Tip bracket by removing the
kick panel or storage drawer and inspecting the rear leveling leg. Make sure it fits
securely into the slot.
10 Final Check
Be sure all range controls are in the OFF position before leaving the range.
40
Bracket
Screw must
enter wood
or metal
Typical installation of anti-tip bracket attachment to wall.
Wall plate