Replacing the Upper Cover
IMPORTANT:While replacing the upper cover, take note of the following items:
Check that the mainboard is tucked underneath the housing wells in the lower cover
•
Check that the speaker cable is attached
•
Check that the antenna cables are tucked inside the housing well and do not interfere with the card reader
•
Antenna cables must be secured to the chassis walls with the provided gasket tape
•
Antenna cable on the right side must pass through the right side of hinge block
•
Make sure that the 40-PIN Cable doesn`t interfere with the speaker module
•
1. Place the upper cover over the lower base, hinge
side first.
3. Replace the five securing screws on the Upper
Cover.
Chapter 3
2. Set the Upper Cover down on the lower base and
press down as shown.
4. Reconnect the touchpad FCC cable and close the
cable latch.
75