Interconnecting, Oscillator Control, And Power Cord Connections; Travel Width And Center Position Internal Adjustment - Miller Electric Weld Oscillator Owner's Manual

2-7. Interconnecting, Oscillator Control, and Power Cord Connections

2

2-8. Travel Width And Center Position Internal Adjustment

2
Tools Needed:
1/4 in
OM-1085 Page 14
3
4
3
1
5
1
1 Oscillator Control
2 Oscillating Slider Assembly
3 Interconnecting Cord
Connect cord to matching recep-
tacles on control and slider.
4 Oscillator Control Cord
Connect cord to matching recep-
tacles on control and slider.
5 115 Volts AC Power Cord
Connect twistlock plug to recep-
tacle on control. Connect plug on
remaining end of cord to matching
grounded and protected (time delay
fuses or circuit breakers) 115 volts
ac receptacle.
ST-052 310-A
.
The unit is shipped from the
factory with the travel width set
for 1/8 to 1-1/2 in (3 to 38 mm).
Adjustments can be made for
total slide travel of 5 in (127
mm).
Remove oscillator control wrapper.
1 Mounting Bracket
2 Potentiometer R13 For Travel
Width
3 Dual Potentiometer R9 And
R11 For Center Position
.
When travel width is increased,
the center position must be de-
creased or slide internal com-
ponents may hit the ends of the
housing.
Rotate R13 in a counterclockwise
direction to increase travel width.
Decrease center position by rota-
ting R9/R11 clockwise.
Reinstall unit wrapper.
Apply power and check adjust-
ments. Repeat procedure until ad-
justment is satisfactory.
ST-052 705-A