Threading Welding Wire For Mig Gun - Miller Electric Millermatic 350P Owner's Manual

5-13. Threading Welding Wire For MIG Gun

1
Open pressure assembly.
Close and tighten pressure
assembly, and let go of wire.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
OM-1327 Page 26
.
A complete Parts List is available at www.MillerWelds.com
6
3 5
2 4
.
Pull and hold wire; cut off end.
.
Tighten
Use pressure indicator scale to set
a desired drive roll pressure.
Pressure
1
Indicator
2
3
Scale
4
Remove gun nozzle and contact tip.
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
7
8
Hold wire tightly to keep
it from unraveling.
6 in.
(150 mm)
Push wire thru guides into gun;
continue to hold wire.
Tighten
1
2
3
4
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Drive Roll
5 Intermediate Wire Guide
6 Outlet Wire Guide
7 Pressure Adjustment Knob
8 Gun Conduit Cable
Lay gun cable out straight.
Tools Needed:
Turn On.
Cut off wire. Close
and latch door.
Ref. 803 544-C / 803 570-C / S-0627-A