Table of Contents
Advertisement
5. Connecting Front Panel cable
Attach the power LED, speaker, and reset switch connectors to the corresponding
pins. If you enable "Suspend Mode" item in BIOS Setup, the ACPI & Power LED
will keep flashing while the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is 2-pin female
connector from the housing front panel. Plug this connector to the soft-power
switch connector marked SPWR.
6. Connecting ATX Power Cables
This motherboard comes with a 20-pin and 4-pin ATX power connector as shown
below. Make sure you plug in the right direction. We strongly recommend you to
insert the 4-pin connector before connecting the 20-pin connector.
After you finish the setting of jumpers and connect correct cables. Power
on and enter the BIOS Setup, press <Del> during POST (Power On Self
Del
Test).
performance.
Warning: Please avoid of using "Load Turbo Defaults", unless you are sure your
system components (CPU, RAM, HDD, etc.) are good enough for turbo setting.
You can use the autorun menu of Bonus CD disc. Choose the utility or driver, select
model name and complete installation.
+12V
+12V
Ground
Ground
7. Power-on and Loading BIOS Setup
Choose "Load Setup Defaults" for recommended optimal
8. AOpen Bonus Pack CD
Advertisement
Table of Contents
