Table of Contents
Advertisement
PREPARE TO INSTALL THE RANGE
STANDARD INSTALLATION
9/16" min.
flat
The Standard Installation of this Drop-In Range
is to hang by the countertop on the side metal
flanges under cooktop. This Range must not
be installed on a base or sub structure
(2"x 4" support).
If the construction of your cabinet cannot
provide a 1/4" flat area at the back of the
countertop opening, consider changing the
countertop to accommodate this dimension.
Installation Instructions
1/4" min.
flat
23-3/16"
29-15/16"– 30-1/16"
smooth cut
Wall
25"
typically
9/16" min.
flat
Countertop
1
Center the 30" wide opening over the
adjacent cabinets and mark with a straight
edge.
2
Using a straight edge, mark the back line
at 23-3/16" from the front edge of the
counter.
3
Be careful not to damage the adjacent
cabinets while cutting the countertop.
4
Remove countertop raised edge, if
incorporated. (See illustration on page 4.)
5
Flat
area
R
1/4"
Range support
Braces secured between the
underside of the countertop and
the cabinet if required to obtain
1-1/4" minimum thickness (two
sides)
Advertisement
Table of Contents
