Adapter Plugs; Extension Cords - GE Spacemaker JVM130K Use And Care Manual

REMOVE SCREW
Remove screw on right side of light compartment cover
and lower cover until it stops.
Oven Light
To replace your oven light, first
disconnect power at main fuse or
circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold it
in place.
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
WARNING–improper
use of the grounding plug can-
result in a risk of electric shock.
To replace
disconnect power
at main fuse or
circuit breaker
panel or pull
plug.
with 40-watt incandescent bulbs (WB02X4253)
available from your GE supplier. High intensity 40-watt
bulbs (40S 1 lN/1), which are available in supermarkets
and hardware stores, may also be used for replacements.
Raise light compartment cover and replace screw.
Connect electrical power to microwave oven.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt incandescent bulb
your GE supplier.
PREFERRED
METHOD
Ensure proper ground
Fig. 1 exists before use
Consult a qualified electrician or
. . .- .
service tecnmclan lr the grounalng
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
Where a standard two-prong
wall receptacle is encountered, it
is your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
. .
Do not use an extension cord
with this appliance.
Be sure bulbs to
be replaced are
cool before
removing. Break
the adhesive seal
by gently
unscrewing the
bulbs. Replace
29