Honda XR125LK Owner's Manual page 91

12/04/20 17:07:42 32KRHA20_091
1. Place a drain pan under the crankcase.
2. To drain the oil, remove the oil fill cap/
dipstick, oil drain bolt ( ), and sealing
washer ( ). 2
3. Operate the kickstarter several times to
aid in complete draining of the remaining
oil.
4. Check that the sealing washer on the
drain bolt is in good condition and install
the bolt. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
Oil drain bolt torque:
30 N·m (3.1 kgf·m , 22 lbf·ft)
5. Fill the crankcase with the recommended
grade oil; approximately:
1.0 (1.1 US qt , 0.9 Imp qt)
6. Install the oil fill cap/dipstick.
7. Start the engine and let it idle for 3 5
minutes.
8. 2 3 minutes after stopping the engine,
check that the oil level is at the upper
level mark on the oil fill cap/dipstick with
the motorcycle on its center stand, level
ground. Make sure there are no oil leaks.
1
(1) Oil drain bolt
(2) (1)
(2) Sealing washer
81