Rear Wheel - Yamaha PW80(Z) Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
3
1. Retainer
4
3. Insert the wheel axle, and then in-
stall the washer and axle nut.
4. Lower the front wheel so that it is
5
on the ground.
5. Connect the brake cable at the
6
wheel hub.
6. Connect the brake cable at the
7
front brake lever.
7. Install the brake cable holder by in-
stalling the bolt.
8
8. Tighten the axle nut to the speci-
fied torque.
9
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25.3 ft·lbf)
9. Adjust the brake lever free play.
(See page 7-13.)
10. Push down hard on the handlebar
several times to check for proper
fork operation.
1

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Drive chain slack adjusting nut
2. Locknut
3. Chain puller
4. Washer
5. Axle nut
7-24
WARNING
1. Loosen the axle nut.
2
1
5
3
4
2. Remove the brake pedal free play
adjusting nut, and then disconnect
EAU25080
EAU41562
EWA10821