Cleaning The Spark Arrester - Yamaha PW80(Z) Owner's Manual

4. Apply oil of the recommended type
to the entire surface of the sponge
material, and then squeeze the ex-
cess oil out.
TIP
The sponge material should be wet but
not dripping.
Recommended oil:
Yamaha foam air filter oil or other
quality foam air filter oil
5. Install the sponge material onto
the air filter case cover.
6. Insert the air filter element into the
air filter case. NOTICE: Make sure
that the air filter element is prop-
erly seated in the air filter case.
The engine should never be op-
PERIODIC MAINTENANCE AND ADJUSTMENT
erated without the air filter ele-
ment installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
7. Install the air filter case cover by in-
stalling the screws.
7-9

Cleaning the spark arrester

The spark arrester should be cleaned
at the intervals specified in the periodic
[ECA10481]
maintenance and lubrication chart.
WARNING
G Always let the exhaust system
cool prior to touching exhaust
components.
G
Do not start the engine when
cleaning the exhaust system.
1. Remove the tailpipe by removing
the bolt, and then pulling it out of
the muffler.
1
1. Bolt
2. Tap the tailpipe lightly, and then
use a wire brush to remove any
EAU41232
EWA10980
2
3
4
5
6
7
8
9