Manually Lighting The Rotisserie Burner; To Extinguish - Weber Vieluxe 27 Built-In Grill Owner's Manual

Built-in liquid propane gas grill
Hide thumbs Also See for Vieluxe 27 Built-In Grill:
Table of Contents

Advertisement

MANUALLY LIGHTING THE ROTISSERIE BURNER

Summary lighting instructions are printed on a card located inside of the door of grill.
WARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found
to be damaged in any way, do not use the grill. Replace using only Vieluxe
Contact Vieluxe
®
Customer Service at 1-866-VIELUXE.
1
Open the lid.
2
Remove rotisserie cover by tilting the bottom of the cover towards you as you lift it off of the rotisserie burner.
Failure to open the lid while igniting the grill's burners, or not waiting 5 minutes to allow the gas to clear if the
grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.
3
Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwise to ensure that it is
in the OFF position.)
WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane
cylinder tank valve. If they are not in the OFF position when you turn on the LP cylinder valve, the
"excess gas flow control" feature will activate, limiting the flow of gas from the LP cylinder. If this should
occur, turn OFF the LP cylinder valve and burner control knobs. Then start over.
When the "excess gas flow control" feature is activated, a small amount of gas is still flowing to the burners.
After turning OFF the cylinder knob, wait at least 5 minutes for the gas to clear before attempting to light the
grill. Failure to do so may result in an explosive flame-up, which can cause serious bodily
injury or death.
4
Turn on the gas supply.
5
Put a match in the match holder and strike the match.
6
Hold match holder and lit match by right side of
rotisserie burner.
WARNING: Do not lean over the open grill.
7
Push rotisserie burner control knob down and turn to
HI/START. Continue to hold the control knob down.
8
Continue to hold the control knob down for
ten seconds after the burner has ignited. Check
that the burner is lit by looking for the rotisserie burner
to glow red.
WARNING: If the rotisserie burner does not
light, turn the burner control knob to OFF and
wait 5 minutes to let the gas clear before you
try again.

To extinguish

Push down and turn the rotisserie burner control knob
clockwise to OFF position. Turn gas supply OFF at the
LP cylinder or gas source.
DANGER
DANGER:
Vieluxe
®
27" Built-In
®
authorized replacement hose.
Vieluxe
7
®
39" Built-In
23

Advertisement

Table of Contents
loading

Table of Contents