HP R1500 - UPS XR User Manual page 7

9. Following the diagram on the back of the UPS below the
terminal block:
a. Connect the input wires to the ground and the input
terminal block connections (1).
b. Connect the output wires to the output terminal block
connections (2) and (3).
c. Verify that no loose strands remain and that the terminal
connection screws are tightened to torque specifications
found on the diagram below the terminal block.
10. Replace the wiring port cover by first inserting the screws (1),
then the single screw (2). Replace the terminal block cover (3),
secure the cover (4), and insert and tighten the screws (5).
5
2
1 2 3
4
3
1
5
Completing the UPS Assembly
Inserting the Electronics Modules
1. Insert the four electronics modules, bottom to top.
CAUTION: Do not damage the LED power cable (1) when inserting
the top battery module.
2. After each electronics module is seated properly, close the latch
on the front of the module to secure the module in place. Lift
the hook latch (1), and slide the panel down (2). Tighten the
screw (3).
1
2
3
1