Parameters; Memory Map - Toshiba AD268 User Manual

PART 2 DA264

6. Parameters

The DA264 has the memory that stores the control parameters, output type designation,
module status information, etc. This memory is called the buffer memory. To access
(read/write) this memory from the T2 program, READ and WRITE instructions are used.
These parameter data are not maintained in the DA264. Therefore, you should write the
necessary parameter data at each time of the beginning of the operation.

6.1 Memory map

The contents of the DA264's buffer memory are as follows.
Address
H8000
H8001
H8002
H8003
H8004
H8005
H8006
H8007
H8008
H8009
H800A
H800B
H800C
H800D
H800E
H800F
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Contents
F
Offset calibration value for channel 1
Offset calibration value for channel 2
Offset calibration value for channel 3
Offset calibration value for channel 4
Output type setting for channel 1
Output type setting for channel 2
Output type setting for channel 3
Output type setting for channel 4
Analog output read-back value for channel 1
Analog output read-back value for channel 2
Analog output read-back value for channel 3
Analog output read-back value for channel 4
Module status for channel 1
Module status for channel 2
Module status for channel 3
Module status for channel 4
0
Use WRITE instruction to write
data into these addresses.
Use READ instruction to read
data from these addresses.
6. Parameters
51
User's Manual