GE JKP85 Owner's Manual page 34

Care and cleaning of the cooking center.
Lift the door straight up and off
the hinges.
Slot
Hinge arm
Hinge lock (unlocked position)
Removal position
The gasket is designed with a gap at the
bottom to allow for proper air circulation.
Do not rub or clean the door gasket—
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it has
become displaced on the door, you should
have it replaced.
34
Lift-Off Oven Door (on some models)
The oven door is removable for easier
access to the lightbulb.
Do not lift the door by the handle.
To remove the door, open it to the broil
stop position. Grasp firmly on each side
and lift the door straight up and off
the hinges.
Lift-Off Oven Door (on some models)
The oven door is removable for easier
access to the lightbulb.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. This may require a tool.
Firmly grasp both sides of the door
at the top.
Close door to the door removal
position, which is halfway between
the broil stop position and fully
closed.
Lift door up and out until the hinge
arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door
at the top.
To clean the inside of the door:
Because the area inside the gasket is
cleaned during the self-clean cycle, you
do not need to clean this by hand.
The area outside the gasket and
the door liner can be cleaned with a
soap-filled steel wool or plastic pad, hot
water and detergent. Rinse well with a
vinegar and water solution.
To clean the outside of the door:
Use soap and water to thoroughly
clean the top, sides and front of the
oven door. Rinse well. You may also
use a glass cleaner to clean the glass on
Do not place hands between the hinge and the
oven door frame.
To replace the door, make sure the hinges
are in the broil stop position. Position the
slots in the bottom of the door squarely
over the hinges and slowly lower it over
both hinges.
With the door
Bottom
at the same
edge
angle as the
of slot
removal
position, seat the
indentation of the
hinge arm into the
bottom edge of the
hinge slot. The notch in the hinge
arm must be fully seated into the
bottom of the slot.
Fully open the door.
Push the hinge locks up against the
front frame of the oven cavity, to the
locked position.
Locked position
Sealed hinge arm
Close the oven door.
the outside of the door. Do not let
water drip into the vent openings.
If any stain on the door vent trim is
persistent, use a soft abrasive cleaner
and a sponge-scrubber for best results.
Spillage of marinades, fruit juices,
tomato sauces and basting materials
containing acids may cause
discoloration and should be wiped up
immediately. When surface is cool,
clean and rinse.
Do not use oven cleaners, cleaning
powders or harsh abrasives on the
outside of the door.
Hinge arm
Indentation