HP Surestore Tape Library Model 20/700 Installation Notes page 3

Figure 1. Removing Right Rear Cover (Continued)
Removing Right Rear Cover (a5605a_01)
1. Rear Cover
2. Mushroom (6x)
3. Lock-Down Latch Tool
4. Lock-Down Latch
5. Mushroom (Ref)
6. Mushroom (Ref)
4. Slide cover up and set aside.
5. Using a T30 Torx driver, remove the mushrooms from the tape library frame (6 places) in
6. Position the robotic hand at the top of the Z-column and point it toward the drives.
7. Using a T15 Torx driver, remove the twelve No. 6-32 x 3/8-in. Torx Pan Head screws
8. If required, remove any customer data cartridges from the cells in Panel 2, Column 3 and
9. Remove the array retainer clip and the arrays from Panel 2, Column 3 and 4.
10. Reposition the robotic hand to point to Panel 2, Column 4 (where arrays were removed in
11. Remove theta stop closest to the drives using a flat blade screwdriver (see Figure 2).
the area where the cover was removed (see Figure 1).
CAUTION: Be careful not to hit your head on the theta lock down bracket
mounted to the top inside surface of the tape library frame.
holding the front left plate to the drive tower (see Figure 2). Set the screws and plate aside.
4. Be careful not to damage the cartridges.
Note: The array labels appear directly above the arrays.
Step 7).
62108 3