HP Surestore Tape Library Model 10/180 Manual page 2

Step 1
Step 2
Step 3
Step 4
313670504 (Rev D)
Ensure the library is powered on and initialized.
Connect your Ethernet cable to the ENET connector on the
electronics module bulkhead.
This allows you to communicate with the Web-Based
Library Administrator.
See Figures 1 and 2 for the connection diagram.
Set up your Internet Protocol (IP) Address from the Operator
Panel.
After you have powered on or reset the library, the library
performs a reset. When the reset is complete, the Operator
Panel displays a status screen.
a. Press MENU.
The MAIN MENU is displayed.
b. Arrow to CONFIGURATION and press SELECT.
The CONFIGURATION MENU is displayed.
c. Arrow to NETWORK CONFIG and press SELECT.
The NETWORK CONFIG MENU is displayed.
d. Arrow to IP ADDRESS and press SELECT.
An edit window is displayed.
Follow the directions on the Operator Panel for
entering and saving data.
e. Press MENU.
f. Perform a reset to save the changes.
Set up your Subnet Mask from the Operator Panel.
2