HP SureStore 220mx User Manual page 52

NOTE
CAUTION
Operating the Jukebox
Setting the SCSI IDs
If your host computer system does not support multiple types at the same ID and
you want to use LUN mode, you must select different IDs for the jukebox controller
(JKBX ID #) and the drives (DRV #). Tables in Appendix B show jukebox default
settings and an example of setting the jukebox controller and drives to different IDs
(one digit apart).
If another device ID is placed between the jukebox controller and the drives,
problems can result. For this reason, the jukebox will not accept IDs for the jukebox
controller and drives that are more than one digit apart. You will receive a
CONFLICT message.
6. Press or
NEXT PREV
.
ENTER
If the jukebox is set to LUN MODE ON, go to Step 8. Only one ID can be
changed and the ID automatically updates when you press
7. (If using basic SCSI addressing - LUN mode OFF) Press
displays, and then press
8. UPDATE or WAIT FOR UPDATE and then ID'S SAVED displays briefly.
• If the new settings do not conflict with other SCSI IDs on the bus, SCSI
ID'S displays.
• If the new settings conflict with other IDs on the SCSI bus,
CONFLICT-ABORTED displays briefly and then VIEW ID'S displays.
Any changes entered are lost, and you must repeat steps 3 through 6 to set a
new ID.
When in LUN mode:
If the new ID you choose results in the IDs for the jukebox controller and the drives
being more than one digit apart, the jukebox displays CONFLICT and rejects the
ID.
9. Press until READY displays.
CANCEL
Turning off the jukebox in the next step could cause data loss if not done correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Check your host system manuals for information about checking the SCSI bus
status. If your computer is connected to a LAN, be sure to check with your system
administrator before turning off power to the jukebox.
10. Turn the jukebox OFF, then ON to save the IDs to the jukebox flash ROM.
3-18
until the new ID that you want displays and then press
.
ENTER
.
ENTER
until UPDATE
NEXT
Chapter 3