HP Brocade BladeSystem 4/12 Release Note page 16

slptool commands
Use the following slptool commands to verify whether the SLP is operating properly:
slptool findsrvs service:service-agent
Use this command to verify that the Management application SMI Agent SLP service is properly
running as a Service Agent (SA). Example output:
service:service-agent://127.0.0.1,65535.
slptool findsrvs service:wbem
Use this command to verify that the Management application SMI Agent SLP service is properly
advertising its WBEM services. Example outputs:
◦
service:wbem:https://10.0.1.3:5989,65535
◦
service:wbem:http://10.0.1.3:5988,65535
This output shows the following functionalities of the Management application SMI Agent:
It accepts WBEM requests over HTTP using SSL on TCP port 5989.
It accepts WBEM requests over HTTP without SSL on TCP port 5988.
◦
slptool findattrs service:wbem:http://IP_Address:Port
Use this command to verify that Management application SMI Agent SLP service is properly
advertising its WBEM SLP template over the HTTP protocol. Example input: slptool
findattrs service:wbem:http://10.0.1.2:5988 .
NOTE:
use the slptool findsrvs service:wbem command.
◦
slptool findattrs service:wbem:https://IP_Address:Port
Use this command to verify that the Management application SMI Agent SLP service is
properly advertising its WBEM SLP template over the HTTPS protocol. Example input:
slptool findattrs service:wbem:https://10.0.1.2:5989
NOTE:
use the slptool findsrvs service:wbem command.
SLP on UNIX systems
This section describes how to verify the SLP daemon on UNIX systems. The following are SLP file
locations on UNIX systems:
SLP log—Management_Application/cimom /cfg/slp.log
SLP daemon—Management_Application/cimom /cfg/slp.conf
The SLP daemon can be reconfigured by modifying SLP
register—Management_Application/cimom /cfg/slp.reg.
You can statically register an application that does not dynamically register with SLP using SLPAPIs
by modifying this file. For more information about these files, read the comments contained in
them, or see http://www.openslp.org/doc/html/UsersGuide/index.html.
Verifying SLP service installation and operation on UNIX systems:
1. Open a command window.
2. Enter % su root and press Enter to become the root user.
16
IP_Address:Port is the IP address and port number that display when you
IP_Address:Port is the IP address and port number that display when you