Roni 9000 rp7440 Manual page 7

5. Take the power package and let it slide into the slot on the rear of the lift mast. Then lower it until
it stops just above the mast mounting yoke and tighten the handle. Plug the motor cable into its
outlet on the power package.
6. Take the handle and let it slide into the slot on the backside of the lift mast and lock it in place at a
comfortable height. Make sure that the remote control holder is placed on the handle in an
adequate position. Then place the remote control on the remote control holder in the keyhole slot
and plug in the controller to the electronic power pack.
7. Lift the end-effector up and tilt the mounting post down so that the mounting lugs can be placed
in the
slot located at the top of the mast yoke. Make sure that the mounting lugs are seated in the
bottom of the slot and then lower the front of the end-effector until the bottom mounting lugs
engage the horizontal slot on the mast yoke.
The lifter is now ready to operate.
Lift-O-Flex 17000 SP 400 Manual
Page 6 Rev July 01