Assembly Instructions; Assembly - Roni 9000 rp7440 Manual

2. Assembly instructions

Each lifter is to be delivered in modules and will be shipped in cardboard box(s). Components are as
indicated below.
Leg-RH
Brake Rod

2.1 Assembly

Assembly instructions
1. Place the intermediate section without lift motor attached and stand it on its end on the floor.
Make sure that the mast collar hold down clip is facing to the rear of the lifter. (See picture on
next page). Take the four flathead hex screws (M 8 x 30 mm), take one of the legs and mount the
leg to the frame with the 5mm Allen wrench enclosed.
2. Turn the intermediate section with one leg attached on its side and insert the brake rod (item 13 or
14) at a forward angle (the wheels are now in the locked position) into the hexagon hole situated
above the wheel. Take the next leg and insert the brake rod into its hexagon hole located above
the wheel and secure the leg with the screws as described above. Check to make sure both rear
casters are in the locked position prior to bolting final leg to intermediate section.
Next, slip the lift motor intermediate section into the leg channels provided at the front of the
lifter base. Remove quick disconnect pin from rear bracket prior to sliding lift motor intermediate
section into position. Lock it into place by re-inserting the quick disconnect pin.
Lift-O-Flex 17000 SP 400 Manual
Leg-LH
Page 4
Lift Mast
End-Effector
Fixed Forks
Intermediate Section
Handlebar
w/Remote
Controller
Electronic Power
Pack with ground
cable attached
Rev July 01