Maintenance - Roni 9000 rp7440 Manual

3.3

Maintenance

Regular maintenance is important to protect the continued use of the LIFT-O-FLEX lifter.
Daily maintenance
1.
Wash the lifter with a detergent suitable for powder coat surfaces, aluminium and stainless steel.
Follow the instructions on the detergent. Wipe the lifter dry. Do not use a high-pressure hose. It
could damage both the electronics as well as the chassis.
3. The batteries are to be charged every night or when the lifter is not being used for a long period of
time. The batteries cannot be "over charged".
Every 6 month maintenance
1.
Electrical connections: Check all connections and have any items that show wear or damage repaired.
Replace if needed.
2.
Bolts and screws: Check that all bolts and screws are tight.
3. Lift mast: Take the mast out of the base frame. Wipe it clean and lubricate it with ball bearing grease.
When the mast is out of the intermediate section the bristles in the mast are to be taken out from the
bottom of the mast and cleaned. At the same time the screw can be lubricated with ball bearing
grease. Assemble the mast, see 2.1 Assembly, and check that the end-effector is operating properly.
4.
Wheels: Check that all wheels run smoothly and lubricate the ball bearings regularly. Check that the
wheel rubber is not worn or damaged.
5. Central brake system: Check that all brake positions are operating properly:
• Rear wheels locked (brake rod is in lower (horizontal) position)
• Neutral, casters are unlocked (brake rod is in middle position)
• Directional lock engaged (brake rod is in the upper (vertical) position)
6.
Quick disconnect handle for handlebar and the mounting bracket for remote control and power pack:
Check that the quick disconnect handles can be loosened and tightened properly.
7.
Identification and warning signs: Check that the signs are well attached and can be read. They are
mounted for your safety.
Lift-O-Flex 17000 SP 400 Manual
Page 10 Rev July 01