Troubleshooting - Roni 9000 rp7440 Manual

Directional wheel locks
When moving a heavy load, it is both easier and safer if you use the directional wheel locks by moving
the red bar into the upper position. Both back wheels are now locked in a straightforward position. This
gives greater directional stability when moving heavy loads. Observe that it is especially important that a
heavy load be kept as low and as centered on the end-effector as possible.

3.2 Troubleshooting

The LIFT-O-FLEX
procedures are followed according to the instruction manual. A guide for trouble shooting is provided as
listed below should any problems arise. If the problem remains after referring to the troubleshooting
guide below - contact RONI, LLC in Charlotte, NC.
Symptom
1. The lifter does not run at all.
2. The end-effector cannot be
lowered or raised but the motor runs.
3. The end-effector moves at a slower
speed than normal
4. When lifting there is a strange sound
and/or the lifter operates differently
than usual.
Lift-O-Flex 17000 SP 400 Manual
has been designed to operate safely and effectively provided that maintenance
Page 9
Action
A) Check the voltage of the battery (18 Volts).
B) Inside the power package where the batteries are
located is a 20-ampere fuse (T16L-250V). Check
that it's intact and operable.
C) Check that the connections to the battery charger
have been connected properly during recharge.
D) Check that the maximum load is not exceeded.
A) Check that the mast is positioned correctly in
the intermediate section. See above 2.1 Assembly.
A) See above 1A, 1C and 1D.
A) Attend the prescribed actions under 3.5
Maintenance
Rev July 01