Displaying And Maintaining Trill - HP 6125XLG Configuration Manual

GR Helper—A neighbor of the GR Restarter. It helps the GR Restarter to complete the GR process.
•
To configure TRILL GR:
Step
1. Enter system view.
2. Enter TRILL view.
3. Enable GR for TRILL.
4. (Optional.) Configure
the GR interval for TRILL.

Displaying and maintaining TRILL

Execute the display commands in any view and the reset command in user view.
Task
Display TRILL ardency table
information.
Display brief TRILL information.
Display TRILL FIB information.
Display TRILL GR status.
Display TRILL port information.
Display TRILL LSDB information.
Display all ingress entries in the TRILL
multicast FIB (MFIB).
Display all egress entries in the TRILL
MFIB.
Display information about the TRILL
multicast routing table.
Display the TRILL neighbor table.
Display the TRILL neighbor statistics.
Display the TRILL RPF check table
information.
Display information about the TRILL
unicast routing table.
Clear dynamic running statistics of
the TRILL process.
Command
system-view
trill
graceful-restart
graceful-restart interval
interval
Command
display trill adjacent-table [ count | nickname nickname interface
interface-type interface-number ]
display trill brief
display trill fib [ count | nickname nickname ]
display trill graceful-restart status
display trill interface [ interface-type interface-number ]
display trill lsdb [ local | lsp-id lsp-id | verbose ] *
display trill mfib ingress [ vlan vlan-id [ local-entry | remote-entry ] ]
display trill mfib transit [ nickname nickname [ prune-entry | rpf-entry
| vlan vlan-id [ mac-address mac-address ] ] ]
display trill multicast-route [ tree-root nickname [ vlan vlan-list
[ mac-address mac-address ] ] ]
display trill neighbor-table
display trill peer [ interface interface-type interface-number ]
display trill rpf-table tree-root nickname
display trill unicast-route [ verbose ]
reset trill
12
Remarks
N/A
N/A
By default, GR is disabled for TRILL.
The default setting is 300 seconds.