HP 6125XLG Configuration Manual page 9

When you set up a TRILL network, avoid the case that multiple TRILL neighbors are established for
•
one RB port, as shown in
Figure 4 shows a typical network where two TRILL neighbors are established for the same port
of an RB.
In Figure 5, because TRILL is not enabled on the port connecting RB2 to RB3, the port will
transparently transmit the TRILL Hello frames from RB3. As a result, two TRILL neighbors are
established for the port connecting RB1 to RB2.
Figure 4 Two TRILL neighbors are established for a port (1)
RB 1
Traditional Ethernet
switch
RB 2
TRILL enabled port
Figure 5 Two TRILL neighbors are established for a port (2)
After you enable TRILL on a port, TRILL can operate correctly by using default settings. A port with TRILL
enabled is called a "TRILL port."
To enable TRILL:
Step
1. Enter system view.
2. Enable TRILL globally
and enter TRILL view.
3. Return to system view.
Enter Ethernet or
4.
aggregate interface
view.
5. Enable TRILL on the
port.
Figure 4 and Figure
RB 3
Command
system-view
trill
quit
interface interface-type
interface-number
trill enable
6
5.
Remarks
N/A
By default, TRILL is disabled globally.
N/A
N/A
By default, TRILL is disabled on a port.