Configuration Procedure - HP 6125G Configuration Manual

Figure 13 Network diagram
GE1/0/2
Device A

Configuration procedure

This example assumes that the system names of Device A, Device B and Device C are DeviceA, DeviceB,
and DeviceC respectively before the IRF fabric is formed.
Assign member IDs:
1.
# Keep the default member ID of Device A unchanged.
# Change the member ID of Device B to 2.
<DeviceB> system-view
[DeviceB] irf member 1 renumber 2
Warning: Renumbering the switch number may result in configuration change or loss.
Continue? [Y/N]:y
[DeviceB]
Power off the devices, connect IRF links as shown in
2.
Configure IRF port bindings:
3.
# Bind Ten-GigabitEthernet 1/1/2 to IRF-port 1/2 on Device A and save the configuration.
<DeviceA> system-view
[DeviceA] interface ten-gigabitethernet 1/1/2
[DeviceA-Ten-GigabitEthernet1/1/2] shutdown
[DeviceA-Ten-GigabitEthernet1/1/2] quit
[DeviceA] irf-port 1/2
[DeviceA-irf-port1/2] port group interface ten-gigabitethernet 1/1/2
[DeviceA-irf-port1/2] quit
[DeviceA] interface ten-gigabitethernet 1/1/2
[DeviceA-Ten-GigabitEthernet1/1/2] undo shutdown
[DeviceA-Ten-GigabitEthernet1/1/2] save
# Bind Ten-GigabitEthernet 2/1/1 to IRF-port 2/1 on Device B and save the configuration.
<DeviceB> system-view
[DeviceB] interface ten-gigabitethernet 2/1/1
[DeviceB-Ten-GigabitEthernet2/1/1] shutdown
[DeviceB-Ten-GigabitEthernet2/1/1] quit
Device C
GE1/0/1 GE1/0/2
IRF
XGE1/1/2 XGE2/1/1
(IRF-port1/2) (IRF-port2/1)
IP network
GE2/0/1
Device B
Figure
29
13, and power on the two devices.