Step
2.
Enter Ethernet interface view
or interface range view.
3.
Shut down the port or ports.
4.
Return to system view.
5.
Enter IRF port view.
6.
Bind each physical port to
the IRF port.
7.
Return to system view.
Command
•
Enter interface range view:
Approach 1:
interface range
{ interface-type
interface-number [ to
interface-type
interface-number ] }
&<1-5>
Approach 2:
interface range name
name [ interface
{ interface-type
interface-number [ to
interface-type
interface-number ] }
&<1-5> ]
•
Enter interface view:
interface interface-type
interface-number
shutdown
quit
irf-port member-id/port-number
port group interface interface-type
interface-number [ mode
{ enhanced | normal } ]
quit
16
Remarks
To shut down a range of physical IRF
ports, enter interface range view.
To shut down one physical IRF port,
enter its interface view.
Always shut down a physical port
before binding it to an IRF port or
removing the binding.
Start the shutdown operation on the
master and then the switch that has
the fewest number of hops from the
master.
N/A
N/A
By default, no physical port is bound
to any IRF port.
Make sure the two ends of an IRF link
use the same binding mode.
N/A