Hot Water - Toshiba HWS-803XWHM3-E Owner's Manual

Hydro Unit
Performing Auto mode operation
• The setting temperature can be set automatically
according to the outside temperature.
• Press the AUTO TEMP.
• The temperature indication changes to "A" and the
water temperature is automatically set according to
the outside temperature.
To correct the set value for the Auto mode
• Press the AUTO TEMP.
seconds or more to enter the auto curve adjusting
mode.
• The function code setting screen appears. Press the
TIME button to display a temperature
between -5 to +5°C.
In this case, temperature is displayed as -5, -4, -3,
-2, -1, 0, 1, 2, 3, 4, or 5.
Only ZONE1 temperature is displayed.
When the SET button is pressed after the
temperature is changed, the set temperature is
registered.
• When the TEST button is pressed, the
registered data is determined. The unit exits the
function code setting mode and "A" appears on the
display.
• Each time AUTO TEMP.
the mode changes as follows:
No indication
(cancel)
button.
button for 4
button is pressed,
Auto
– 8 –

Hot water

Performing hot water supply operation
• Press the HOT WATER
hot water supply operation.
• The set temperature appears under
the remote controller, and
• During the heat pump operation or while the internal
heater is energized,
Setting temperature
• Press the SELECT
and select
• Change the set temperature with the TEMP.
button.
Owner's Manual
button to start the
on
lights.
or is displayed.
button to move
.
EN
8-EN