Fitting The Fan Filter; Connecting The Power Cord - Toshiba B-SX5T SERIES Owner's Manual

2. PRINTER SETUP

2.2 Fitting the Fan Filter

2.3 Connecting the
Power Cord
CAUTION!
1. As a Power Cord is not
supplied with the printer,
please purchase an approved
on that meets the safety
standard of each country.
(Refer to APPENDIX 3.)
2. Make sure that the printer
Power Switch is turned to the
OFF position ( ) before
connecting the Power Cord to
prevent possible electric
shock or damage to the
printer.
3. Connect the Power Cord to a
supply outlet with a properly
grounded (earthed)
connection.
When installing the printer, it is important to ensure that the Fan Filter is
attached before using the printer.
The Fan Filter consists of 2 parts:
(1) Filter Pad
(2) Filter Retainer
To fit the Fan Filter, put the Filter Pad inside the Filter Retainer and
simply press into place as shown in the diagram below, ensuring
connecting pins are aligned with the connecting holes.
Filter Pad
Snap On
Filter Retainer
1. Make sure that the printer Power Switch is in the OFF ( ) position.
Connect the Power Cord to the printer as shown in the figure below.
Power Switch
2. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
Power Cord
[Example of US Type]
E2- 3
ENGLISH VERSION EO1-33059
Snap On
Power Cord
[Example of EU Type]
2.2 Fitting the Fan Filter
Power Cord