Control Panel Access - GE JGBP86SEMSS Technical Service Manual

CONTROL PANEL ACCESS

A
HINGED ON
BACK SIDE
B
BE SURE TAB IS
IN SLOT WHEN
REINSTALLING
VENT DEFLECTOR
Pull control panel
down and forward to
release it from the
vent deflector
REINSTALLING CONTROL PANEL
When reinstalling the control panel, push
up on the vent lip with your fingers. At the
same time pull forward on the control
panel, making sure that the vent lip is
TUCKED UNDER the control panel while
lowering the panel into place.
TUCK VENT LIP UNDER CONTROL
PANEL PRIOR TO LOWER PANEL
LOWER PANEL
INTO PLACE
FLIP PANEL UP TO ACCESS
FLUORESCENT LIGHT
REMOVE 2 SCREWS
TO REMOVE CRYSTAL
SIDE
FRAME
C
LOOSEN
THIS SCREW TO
RAISE CONTROL PANEL
PUSH UP ON
VENT LIP
TO REMOVE CONTROL PANEL
1. Grasp the light panel cover at the rear,
where it is hinged to the control panel. Lift
upward at the rear, just far enough to insert
a small, thin bladed screw driver between
the end cap and the fluorescent light cover.
Slide the blade forward toward the front
while lifting upward on the cover. Be sure to
wrap the blade of the screw driver with tape
so as not to scar the plastic shield.
Remove screws
2.
endcaps to the control console. Be careful
when removing the endcap not to break the
locating tab at the bottom of the endcap.
LOOSEN
3.
This screw is just long enough that it will
protrude into a slot in the side frame,
causing the panel to bind as you slide it
down and forward. Loosening the screw a
couple of turns will back it off enough that it
will no longer protrude into the side frame
slot.
4. Grasp the face panel at the bottom front with
one hand, while gently pushing down on the
top of the control panel with your other. Pull
panel downward to release it from the vent
deflector while at the same time pull the
SPARK MODULE
The spark module is located behind the
control panel, on the right side. You must
remove the control panel to access the
spark module.
BALLAST
– 13 –
A & B, which secure the
screw. C . DO NOT REMOVE.
SPARK
MODULE
TABS