Supervisor Password; Starting The Computer By Password - Toshiba Satellite Pro S850 Series User Manual

Supervisor Password

If you set a Supervisor Password, some functions might be restricted when
a user logs on with the User Password. To set a Supervisor Password:
Start -> All Programs -> TOSHIBA -> Support & Recovery -> TOSHIBA
Assist -> SECURE -> Supervisor password
This utility lets you do the following:

Starting the computer by password

If you have already registered a password, there are several ways to start
the computer:
The password is necessary only if the computer was turned off in boot
mode or Hibernation Mode.
It is not needed in Sleep Mode and Restart.
To enter a password manually, follow the steps as detailed below:
1.
At this point, the hotkeys FN + F1 to F12 do not work. They will function
after you enter the password.
2.
3.
User's Manual
When saving the HDD User Password shut down or restart the
computer. If the computer is not shut down or restarted, the saved
data may not be correctly reflected. For more information on shutting
down or restarting the computer, refer to
Chapter 1.
Register or delete the Supervisor Password.
Specify restrictions for general users.
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint System
Pre-Boot Authentication. If you would not like to swipe your finger or
cannot authenticate the fingerprint for some reasons, push the BACK
SPACE key to skip the fingerprint authentication screen. You can try
to swipe the fingerprint up to five times. If you failed fingerprint
authentication five times, you must enter the password manually to
start the computer.
Enter the password manually.
Turn on the power as described in Chapter 1,
following message will appear in the screen:
Password=
Enter the Password.
Press ENTER.
Turning on the power
Getting Started. The
in
4-17