Information; Input Source Information Display - Panasonic PT-EX500U Operating Instructions Manual

Information

Select [Information] from the Main Menu (see
"Navigating through the menu" on page 46),
then select the item from the sub-menu.
Remote Control
Input Source Information
Display
The Information Menu is used for checking the status
of the image signal being projected and the operation
of the projector.
You can also press the <INFO> button on the remote
control to display the Information menu.
Input
J
The selected input source is displayed.
System
J
The selected system is displayed.
H-sync freq.
J
The selected H-sync freq. is displayed.
The horizontal frequency of the input signal is
displayed in kHz, or - - - kHz when no signal.
V-sync freq.
J
The selected V-sync freq. is displayed.
The vertical frequency of the input signal is displayed
in Hz, or - - - Hz when no signal. Numbers of Hz
doubles when during Interlace.
Screen
J
The selected Screen size is displayed.
Language
J
The selected language is displayed.
Side Control
Lamp power
J
The selected lamp mode is displayed.
Lamp runtime
J
The cumulative lamp operating time is displayed.
Filter counter
J
The filter using time filter is displayed.
Power management
J
[Off] , [Ready] or [Shut down], and [Timer] are
displayed.
Key lock
J
The selected Key lock icon is displayed.
PIN code lock
J
[Off], [On 1] or [On 2] is displayed.
Shutter management
J
To display the setting of [Protection] and time.
* (Only for EZ570 series, EW630 series and EX600
series.)
Simple mode
J
To display the configuration of a simple remote control
mode.
Remote control
J
The selected remote control code is displayed.
Serial number
J
The serial number of the projector is displayed.
The serial number is used to service the projector.
*
71
ENGLISH -