Regulatory Compliance Appendix - Vidyo VidyoRoom HD-220 User Manual

Installation Instructions
A. Elevated Operating Ambient – If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment may
be greater than room ambient. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum
ambient temperature (Tma) of 40° C.
B. Reduced Air Flow – Installation of the equipment in a rack or cabinet
should be such that the amount of airflow required for safe operation of the
equipment is not compromised.
C. Mechanical Loading – Mounting of the equipment in the rack or cabinet
should be such that a hazardous condition is not achieved due to uneven
mechanical loading.
D. Circuit Overloading – Consideration should be given to the connection of
the equipment to the supply circuit and the effect that overloading of the
circuits might have on over current protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when
addressing this concern.
E. Reliable Earthing – Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit. (e.g., use of power strips).
F. Redundant Power Supplies – Where redundant power supplies are provided
with the equipment, each power supply shall be connected to a separate
circuit to optimize the equipment redundancy.
G. Servicing – Prior to servicing the equipment, disconnect all power supplies.
H. Power Supply Cord – The power supply cord is used as the main disconnect
device. Ensure that the socket outlet is located/installed near the equipment
and is easily accessible.
I. Circuit Overloading – This product relies on the building's installation for
short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker
no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the
phase conductors (all current-carrying conductors).
Additional Warnings
Caution: There is danger of explosion if battery is replaced with incorrect type.
Replace the battery with the same type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
TM
41

Regulatory Compliance Appendix