Configuration Parameters - HP T1000 XR User Manual

Configuration
2. Press and hold the Configure button (2) for three seconds. When the Configure button is
released, the front panel configuration parameters flash in unison and the Configure
Mode On LED (1) illuminates solid green.
Figure 3-2: Placing the UPS in Configure mode

Configuration Parameters

In Configure mode, the front panel LED display changes function to allow UPS monitoring.
The LED control buttons allow modification of the UPS configuration parameters. The
configuration parameters are defined in Table 3-1. Available voltage settings per model are
listed in Table 3-2.
Table 3-1: Configuration Parameters
Parameter (LED)
General Alarm
On Battery
Bad Battery/Low
Site Wiring Fault
3-2
HP CONFIDENTIAL Codename: Sherman Part Number: 216164-002 Last Saved On: 8/19/02 4:21 PM
Parameter Name
100 Nom
( )
110/220 Nom
( )
120/230 Nom
Battery
( )
Utility LED 127/240 Nom
( )
Site Wiring
Indicator Fault Indicator
( )
HP Uninterruptible Power System T1000 XR and T1500 XR Models User Guide
1
2
Explanation (when illuminated)
Nominal utility voltage level is selected to 100 VAC.
Nominal utility voltage level is selected to 110/220 VAC.
Nominal utility voltage level is selected to 120/230 VAC.
Nominal utility voltage level is selected to 127/240 VAC.
Audible alarm is enabled if ground is missing, or if line
and neutral connections are reversed.