Installing The Ethernet Card - HP Ethernet Network Interface Card hn230e Quick Start Manual

installing the Ethernet card

1 The following diagram shows where the
Ethernet card will be positioned after you
have installed it as described below starting
with step #2:
Filename: QS Ethernet NIC.doc Title: HP-Print2k.dot
Template: QS Phoneline GW.dot Author: Rob Heiret
Revision #: 65 Page: 3 of 12 Printed: 09/04/01 05:48 PM
2 Remove the computer's cover (refer to the
computer's documentation for instructions).
3 Locate the PCI slots (they are beige or white).
If there is a faceplate covering the slot,
remove it, saving the screw, if any.
4 Firmly press the Ethernet card all the way
into an empty PCI slot until it is snugly
seated.
Note: Be sure to install the card properly to avoid
reopening your computer later.
5 If you removed a screw from a PCI slot
faceplate, screw it into the corresponding
end of the Ethernet card faceplate.
6 Reinstall the cover on the computer.
7 Reconnect the cables to the computer as
noted in step 4 of "before you begin."
Ethernet network interface card
Last Saved By: Elizabeth Stoneburg
3